3412C Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Request a Quote

Maximum Rating800 ekW

Minimum Rating635 ekW

Emissions/Fuel StrategyLow Fuel Consumption

Voltage220 to 480 Volts

Frequency60 Hz

Speed1800 rpm

Duty CycleStandby, Prime

Engine Model3412C TA, V-12, 4-Stroke Water-Cooled Diesel

Bore5.4in

Stroke6in

Displacement1648.86in³

Compression Ratio13:00:01

AspirationTA

Fuel SystemPump and Lines

Governor TypeADEM™ A5

Length - Maximum162.4in

Width - Maximum78.3in

Height - Maximum75in

Dry Weight - Genset (minimum)5761lb

Dry Weight - Genset (maximum)13275lb

Standard

Air cleaner, single element canister type

Single element canister type

Optional

Air cleaner - Dual element

Air cleaner - Heavy element

Air cleaner - single element

Standard

High coolant temperature

Customer data link (Modbus RTU)

Low coolant temperature

Low coolant level

Communications:

Run/auto/ stop/control

Engine cycle crank

Generator temperature monitoring module

Power factor (per phase & average)

Remote CAN annunciator

Serial annunciator module data link

DC volts

Frequency (Hz)

Operating hours.

Emergency stop pushbutton

Digital I/O module

Local annunciator

Low oil pressure

Oil pressure (psi, kPa or bar)

Emergency stop

Warning shutdowns:

Volts (L-L & L-N)

Remote Serial annunciator

Speed adjust

Amps (per phase & average)

Voltage adjust

EMCP 4.2B

Overspeed

coolant temperature

Digital Indicator for:

RPM

Accessory module data link

Failure to start (overcrank)

Controls:

Compatible with the following optional modules:

Optional

EMCP 4.3, EMCP 4.4

Temperature monitoring package

Vandal proof panel door

Generator running VFC

Earth leakage Ground fault relay

Common alarm/shutdown relay

Standard

Caterpillar extended life coolant

Radiator with guard (sized for 50 degrees C)

Fan and belt guards

Coolant drain line with valve

Optional

Jacket water heater

Radiator duct flange

Radiator removal

Standard

Stainless steel exhaust flex with ANSI style outlet flange

Optional

Muffler 10 dBA attenuation

Manifold and turbocharger guards

Muffler 35 dBA attenuation

Elbow mounting kit

Through wall installation kit

Standard

Primary and Secondary fuel filters

Fuel priming pump

Water separator

Optional

Manual fuel transfer pump

Automatic fuel transfer system

Standard

3 Phase sensing

SR4B self excited

Class F temperature rise

VR6B voltage regulator

Busbar termination

12 Leads

Class H insulation

2:1 Volts/Hz

Reactive droop

Optional

Internal excitation (IE)

Anti-condensation heater

Permanent magnet excitation (PMG)

Oversize and premium generators

Standard

Cat electronic governor

Optional

Electronic load share

Standard

Oil drain line with valve

Lubricating oil

Oil filter

Optional

Manual sump pump

Standard

Base, formed steel with linear vibration isolators between base and engine-generator

Optional

Fuel tank base (1200 Ltr)

Standard

Battery with rack, cables

45 Amp Charging alternator

Fuel shutoff solenoid

24 Volt starting motor

Standard

Paint - Caterpillar yellow except rails and radiators gloss black

Optional

EU Certification

Optional

4 Pole Circuit breakerswith shunt trip

3 Pole Circuit breakers with shunt trip

Power terminal strip

Optional

PGS Test report @ 1.0 power factor

PGS Test report @ 0.8 power factor

Factory witness test

Optional

Oversize battery set

Battery chargers

Heavy duty starting system

Battery disconnect switch

Battery removal

Optional

DC lighting package

Weather protective enclosure (WP)

Sound attenuated enclosure (SA)

CONTACT US

REQUEST A QUOTE

Complete this form to get a quote on the equipment you are interested in.

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    What You Get: A phone call from a rep or agent. A cost estimate for your machine or the project. An in-person consultation if necessary.