Hiring Event in Columbia, South Carolina on April 22nd 4-7pm..
Click Here
Maximum Rating100 ekW
Minimum Rating72 ekW
Emissions/Fuel StrategyU.S. EPA Cert., Tier 3
Voltage110 to 480 Volts
Frequency60 Hz
Speed1800 rpm
Duty CycleStandby, Prime
Engine ModelCat® C4.4
Bore4.1in
Stroke5in
Displacement268.5in³
Compression Ratio16.2:1, 17.25:1, 18.2:1 or 18.3:1
AspirationTurbocharged
Fuel SystemDirect Injection or Common Rail
Governor TypeMechanical
Length - Maximum75.8in
Width - Maximum44.1in
Height - Maximum53.6in
Standard
Air cleaner; light duty with disposable element
Standard
Radiator and cooling fan with guards
Coolant drain line with valve
Fan drive, battery charging alternator drive
Caterpillar extended life coolant
Optional
Low coolant level shutdown
Coolant heater
Low coolant temperature alarm
Standard
GCCP 1.3
Standard
Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
Standard
Standard open set fuel tank/base supplied base, formed steel with single wall integral 8-hour fuel tank
Optional
Skidbase for CALG enclosure sets
Low fuel level alarm
Open set narrow tankbase
Low fuel level shutdown
Compact skidbase for open set
High fuel level alarm
Bunded fuel tank
Standard
Voltage regulator (single phase sensing)
12 Leads
IP23 Protection
Circuit breaker, IEC, 3 pole, mounted in tower panel
Segregated low voltage (AC/DC) wiring panel
Tower panel, IP22, bottom cable entry
Standard
Mechanical and electrical governing system - model dependent
Standard
Oil drain line with valve
Lubricating oil
Standard
Termination points for coolant and lube oil drain lines
Includes lifting provision and drag points
Captive linear vibration isolators between base and engine-generator
Standard
24V battery with rack and cables
Batteries
Standard
Engine and alternator pre-paint, Caterpillar yellow
Optional
Permanent magnet excitation (PMG)
R Frame auxilliary winding
Anti-condensation heater
R Frame auxilliary winding
Quadrature droop kit
LC Frame alternator with coastal insulation protection
3 phase sensing
Optional
Circuit breaker upgrades - 4 Pole circuit reaker to 250A, 400A and 630 A
Optional
GCCP 1.3
Control panel heater
Earth leakage (2 wire only)
Panel mounted audible alarm
Volt free contacts
Emergency stop with key
Battery charger
Overload shutdown via breaker
Speed adjust potentiometer
Voltage adjust potentiometer
Optional
Sound attenuated Level 2 enclosure
Sound attenuated Level 1 (galv)
Rental pack - CAE rental option only
Optional
Upgrade to STD set for CE
Optional
Certification for CIS
Optional
Electronic governor
Industrial silencer
External single point lift - enclosure
Battery removal
Silencer installation kit
Optional
PGS Test report @ 0.8 power factor
PGS Test report @ 1.0 power factor
Optional
Packing case - compact set
Packing case - canopied set
Stone guards/rad trans flange
Complete this form to get a quote on the equipment you are interested in.
