it's catit's single

D150 GC Generator Set

D150 GC Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Request a Quote

Maximum Rating150 ekW

Minimum Rating150 ekW

Emissions/Fuel StrategyU.S. EPA Cert., Tier 3

Voltage208 to 600 Volts

Frequency60 Hz

Speed1800 rpm

Duty CycleStandby

Engine ModelC7.1 I-6, 4-Cycle Diesel

Bore4.1in

Stroke5.31in

Displacement428in³

Compression Ratio16.7:1

AspirationTurbocharged, Air to Air Aftercooled

Fuel SystemElectronic, Common Rail

Governor TypeADEM™A4

Length - Maximum103.7in

Width - Maximum51.2in

Height - Maximum52.2in

Dry Weight - Genset (maximum)3443lb

Standard

Air cleaner; light duty with disposable element

Standard

GCCP 1.2 Control panel

Standard

Fan drive, battery charging alternator drive

Radiator and cooling fan with guards

Coolant drain line with valves

Caterpillar extended life coolant

Optional

Coolant heater

Low coolant level shutdown

Low coolant temperature

Standard

12 Leads

Segregated low voltage (AC/DC) wiring panel

IP23 Protection

Tower panel, IP22, bottom cable entry

Voltage regulator (single phase sensing)

Circuit breaker, IEC, 3 pole, mounted in tower panel

Standard

Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose

Standard

Standard open set fuel tank/base supplied

Base, formed steel with single wall integral 24-hour fuel tank

Standard

Lubricating oil

Oil drain line with valve

Standard

Termination points for coolant and lube oil drain lines

Captive linear vibration isolators between base and engine-generator

Includes lifting provision and drag points

Standard

24V battery with rack and cables

Standard

Mechanical and electrical governing system - model dependent

Standard

Engine and alternator pre-paint, Caterpillar yellow

Optional

Stone guards/radiator trans flange

Optional

R Frame auxiliary winding: R2273L4 SE aux alt 07, aux alt 08 and aux alt 10

Anti-condensation heater

3 Phase sensing

Quatrature droop king

Alternator removal

Permanent magnet excitation (PMG)

Optional

Padlockable breaker device

4 Pole 250A, 400A and 630A Circuit breakers

Optional

Battery charger

Panel mounted audible alarm

Emergency stop with key

Speed adjust potentiometer

Control panel heater

Earth leakage (2 wire only)

Earth fault (2 wire only)

Speed adjust contacts

Overload shutdown via breaker

Volt free contacts

Optional

Volt free contacts for common alarm

Static battery charger

Volt free contacts for generator set running

Optional

Sound attenuated level 2 enclosure

Optional

Electronic governor

Residential silencer

Industrial silencer removal

Silencer installation kit

Battery removal

Optional

High fuel level alarm

Skidbase for CALG enclosure sets

Compact skidbase for open sets

Open set narrow tankbase

Low fuel level alarm

DEFRA bunded fuel tank

Low fuel level shutdown

Optional

PGS Test report @ 1.0 power factor

PGS Test report @ 0.8 power factor

Optional

Circuit breaker, IEC, 4 pole

Optional

Packing case - canopied set

Packing case - compact set

CONTACT US

REQUEST A QUOTE

Complete this form to get a quote on the equipment you are interested in.

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    What You Get: A phone call from a rep or agent. A cost estimate for your machine or the project. An in-person consultation if necessary.