C175-20

Standby Rating4000(no fan)/3900 kVA

Prime Power Rating3600(no fan)/3500 kVA

Emissions/Fuel StrategyLow Fuel, Low Emissions

Voltage3300 to 11000 Volts

Frequency50 Hz

Speed1500 RPM

Duty CycleStandby, Mission Critical, Prime, Continuous

Maximum Rating4000 kVA

Minimum Rating3150 kVA

Engine ModelC175-20 SCAC, V-20, 4-Stroke Water-Cooled Diesel

Bore6.89in

Stroke8.66in

Displacement6456.31in³

Compression Ratio15.3:1

AspirationTurbo Aftercooled

Fuel SystemCommon Rail

Governor TypeADEM� A4

Length - Minimum261.5in

Length - Maximum330.6in

Width - Minimum85.4in

Width - Maximum330.6in

Height - Minimum87.6in

Height - Maximum150.7in

Dry Weight - Genset (minimum)55100lb

Dry Weight - Genset (maximum)66200lb

Standard

4 x Single element canister air cleaners with service indicator(s).

Standard

Engine cycle crank

Oil pressure (psi, kPa or bar)

Digital Indicators

Coolant temperature

Environmental sealed front face

Frequency (Hz)

True RMS AC metering, 3-phase, +/-2% accuracy

Text alarm/event descriptions

Low coolant level

Volts (L-L & L-N)

Auto/start/stop control

Warning/shutdown Indicators:

Emergency stop pushbutton

Engine cool-down timer

DC volts

High coolant temperature

Operating hours

Low oil pressure

Cat ECS 100

Amps (per phase & average)

4 Programmable relay Inputs

Alarm acknowledge

4 Programmable relay output

Failure to start (overcrank)

Overspeed

Lamp test

24 Volt DC operation

Wall mounted controls

RPM

Standard

SCAC cooling

Coolant sensors

JW Inlet: 6" ANSI / JW Outlet: 5" Cat Flange

AC Inlet: 6" ANSI / AC Outlet: 3-1/2" ANSI

Optional

Package mounted radiators

Remote radiators

Fuel cooler

Standard

Dry exhaust manifold

Bolted flange (ANSI 6" & DIN 150) with bellow for each turbo (Qty 4). 50 Hz

Standard

Filters x 3

Secondary/tertiary fuel filters

4 Micron spin on type

10 Micron spin on type

Engine mounted filters x 3

Primary fuel filter water/fuel water separator

Standard

Salient pole

RFI suppression

Anti-condensation space heater

IEC platinum Stator RTDs

Form wound

NEMA Class H insulation

Voltage regulator

Reactive droop capability

Min/max Exciter limiter

3 Phase voltage sensing

Exciter diode monitor

6 Leads

3 Phase brushless

Right side extension box, bottom cable entry

Permanent magnet excitation (PMG)

Class H temperature rise at 40C ambient

Optional

Medium voltage - 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667

Thermostat for space heater

Generator air cleaner

Differential current transformers - (5, 9 and 15 kV Class)

Standard

ADEM A4

Redundant shutdown (Overspeed protection through a duplicate speed sensing system)

Standard

Oil drain lines and valve

Gear type lube oil pump

Oil filter, filler and dipstick

Integral lube Oil cooler

Lubricating oil

Fumes disposal

Optional

Lube oil heater

Lube oil heater with Crankcase explosion relief valves

Drain group oil pans

Lubricating oil

Electric prelube pumps

Oil filters

Standard

Rails - Engine/Generator

Rubber anti-vibration mounts - shipped loose

Standard

Batteries and battery rack w/cables

Dual 24 volt electric starting motors

Battery disconnect switch

Optional

24 Volt electric starting motor

Air starting motor

Air pressure regulator

Starter location covers

24 Volt battery set - Dry

20, 35 and 50 Amp Battery chargers

Charging alternators - Dry

Jacket water heaters

Standard

SAE standard rotation

Right hand servicing

Paint - Caterpillar yellow with high gloss black rails

Optional

Special paint - 3500, Colors (other than Caterpillar yellow or high performance paints)

US aid emblem

Service tools

Engine barring group

Manual

Engine barring air powered

control GP - air powered bar group

Optional

Single element air cleaner

Optional

EMCP 4.4

Controller and MV and HV power connection locations

Load share module

Controller voltage and current sensing groups

Speed adjust

Annunciator modules

Customer interface options

Generator temperature monitoring

E-Stop

Interconnect harness

Generator harness

Modbus monitoring of packages

Vandal proof panel door

Optional

Explosive relief valves

Crankcase ventilation system

Optional

Front housing - Standby or mission critical

Front housing - Prime or continuous

Exhaust collectors/manifold

Mufflers (15, 25 and 34 dBA)

Optional

Primary fuel filter

Optional

Pyrometer and thermocouples

Optional

Rubber anti-vibration mounts

Spring type linear vibration isolators

IBC vibration isolators - Shipped loose

Optional

Generator test report

PGS Test report @ 1.0 power factor

PGS Test report @ 0.8 power factor

Standard genset TVA (Torsional Vibration Analysis) report

Custom generator TVA report

Special test charge - Engine only

Genset fuel consumption test

Standard engine test charge