it's catit's single

C18 Generator Set

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Request a Quote

Maximum Rating600 ekW

Minimum Rating455 ekW

Emissions/Fuel StrategyLow Fuel Consumption

Voltage208 to 600 Volts

Frequency60 Hz

Speed1800 rpm

Duty CycleStandby, Prime

Engine ModelC18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel

Bore5.71in

Stroke7.2in

Displacement1106.4in³

Compression Ratio14.5:1

AspirationAir to Air Aftercooled

Fuel SystemElectronic unit injection

Governor TypeAdem™A4

Length - Maximum218.5in

Width - Maximum80.9in

Height - Maximum107.8in

Standard

Air cleaner

Standard

Light duty air cleaner

Turbocharger

Aftercooler core

Optional

Dual element air cleaner

Single element air cleaner

Standard

Cat electronic governor (ADEM A4)

Standard

GCCP 1.2

Optional

Protective devices: Earth fault relay - earth leageage Ground fault relay - Overload shutdown via breaker - Low fuel level alarm - Low fuel level shutdown - High fuel level alarm - Fuel level sensor

Local alarm modules

Local alarm horn

Oil temperature displays

GCCP 1.5

Volt free contact

Remote annunciator module

Standard

Radiator and cooling fan with guard

Fan drive, battery charging alternator drive

Coolant drain line with valve

Caterpillar extended life coolant

Package mounted radiator

Standard

Exhaust flange outlet

Optional

Industrial, residential, critical mufflers

Standard

Stainless steel exhaust flex gaskets, raincap and SAE exhaust flange for customer use - shipped loose

Optional

Engine mounted muffler

8 and 10 inch GP flanges

10, 25 and 35 end in / end out mufflers

Manifold and turbocharger guards

8 and 10 inch elbow kits

Standard

Fuel priming pump

Secondary fuel filters

Primary fuel filter with integral water separator

Standard

Standard 8 hour open set fuel tank

Optional

Manual fuel transfer pump

Integral - Dual wall fuel tank base

Fuel transfer system

Standard

Matched to the performance and output characteristics of Cat engines

Integrated voltage regulator (IVR)

Segregated low voltage (AC/DC) wiring panel

A Frame generator - IP21 protection

Integrated voltage regulator (IVR)

Mandatory option circuit breaker, IEC, 3 pole, mounted in power centre

Power center, IP22

Optional

Ingress protection

Permanent magnet excitation (PMG)

A Frame CIP generator

LC frame generator

LC frame oversize generators

A Frame oversize generator

LC frame CIP generator

Space heaters

Standard

IP23 Protection

Matched to the performance and output characteristics of Cat engines

Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time

Optional

Anti-condensation heater

Oversize and premium generators

Excitation: [ ] Permanent magnet excitation (PMG) Excited (PM) [ ] Internally Excited (IE)

Standard

Busbar

Optional

Circuit breakers, UL listed

Circuit breakers, IEC compliant

Standard

GCCP Genset Controller

Standard

Lubricating oil

Oil drain valves

Optional

Manual sump pump

Standard

Rubber vibration isolators

Standard

Captive linear vibration isolators between base and engine-generator. includes lifting provisions and termination points for coolant and lube oil drain lines

Standard

24 Volt battery with rack and cables

24 volt starting motor

Batteries

Optional

Heavy duty starting system

Battery chargers

Jacket water heater

Charging alternator

Oversize batteries

Standard

Engine and alternator pre-paint, Caterpillar yellow

Paint - Caterpillar yellow except rails and radiators gloss black

Optional

CSA Certification

Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007

Integral & sub-base UL listed dual wall fuel tanks

Narrow, wide or skid base

Single or dual wall integral fuel tanks

Automatic transfer switches (ATS)

UL 2200 package

The following options are based on regional and product configuration:

Single or dual wall sub-base fuel tanks

EEC Declaration of Conformity

Sound attenuated, weather protective or high ambient weather protective enclosure

Enclosures: Sound attenuated, weather protective

EU Certificate of Conformance (CE)

Optional

3 Pole (IEC-100% rated) Circuit breakers - Motorised

Power terminal strip

3 Pole (IEC-100% rated) Circuit breakers - Package mounted

Shunt trip for IEC breaker

Padlockable circuit breaker device

Circuit breaker (IEC) Auxiliary contacts

4 Pole (IEC-100% rated) Circuit breakers - Package mounted

4 Pole (IEC-100% rated) Circuit breakers - Motorised

Optional

Load share module

Local & remote annunciator modules

GCCP 1.2, GCCP 1.5

Remote monitoring software

Digital I/O module

Optional

Low coolant temperature alarm

Radiator duct flange

Optional

Sound attenuated enclosures

Optional

Jacket water heaters

5 Amp Battery charger

Battery disconnect switch

CONTACT US

REQUEST A QUOTE

Complete this form to get a quote on the equipment you are interested in.

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

    What You Get: A phone call from a rep or agent. A cost estimate for your machine or the project. An in-person consultation if necessary.