Join the Blanchard Team..
Apply Now
Maximum Rating125 ekW
Minimum Rating125 ekW
Emissions/Fuel StrategyU.S. EPA Cert., Tier 3
Voltage208 to 600 Volts
Frequency60 Hz
Speed1800 rpm
Duty CycleStandby
Engine ModelC7.1 I-6, 4-Cycle Diesel
Bore4.1in
Stroke5.3in
Displacement428in³
Compression Ratio16.7:1
AspirationTurbocharged, Air to Air Aftercooled
Fuel SystemElectronic, Common Rail
Governor TypeADEM™A4
Length - Maximum103.7in
Width - Maximum51.2in
Height - Maximum52.2in
Dry Weight - Genset (maximum)3099lb
Standard
Air cleaner; light duty with disposable element
Standard
GCCP 1.2 Control panel
Standard
Fan drive, battery charging alternator drive
Coolant drain line with valves
Caterpillar extended life coolant
Radiator and cooling fan with guards
Optional
Coolant heater
Low coolant temperature
Low coolant level shutdown
Standard
Segregated low voltage (AC/DC) wiring panel
IP23 Protection
Circuit breaker, IEC, 3 pole, mounted in tower panel
Voltage regulator (single phase sensing)
Tower panel, IP22, bottom cable entry
12 Leads
Standard
Stub pipe, gaskets, raincap and SAE exhaust flange for customer use - shipped loose
Standard
Base, formed steel with single wall integral 24-hour fuel tank
Standard open set fuel tank/base supplied
Standard
Oil drain line with valve
Lubricating oil
Standard
Termination points for coolant and lube oil drain lines
Includes lifting provision and drag points
Captive linear vibration isolators between base and engine-generator
Standard
24V battery with rack and cables
Standard
Mechanical and electrical governing system - model dependent
Standard
Engine and alternator pre-paint, Caterpillar yellow
Optional
Stone guards/radiator trans flange
Optional
Alternator removal
Optional LC Frame alternator
R Frame auxiliary winding: R2273L4 SE aux alt 07, aux alt 08 and aux alt 10
Permanent magnet excitation (PMG)
Anti-condensation heater
3 Phase sensing
Quatrature droop king
Optional
Padlockable breaker device
4 Pole 250A, 400A and 630A Circuit breakers
Optional
Battery charger
Control panel heater
Earth fault (2 wire only)
Volt free contacts
Emergency stop with key
Speed adjust potentiometer
Earth leakage (2 wire only)
Overload shutdown via breaker
Speed adjust contacts
Panel mounted audible alarm
Optional
Volt free contacts for generator set running
Volt free contacts for common alarm
Static battery charger
GCCP 1.2
Optional
Sound attenuated level 2 enclosure
Optional
Silencer installation kit
Residential silencer
Battery removal
Industrial silencer removal
Electronic governor
Optional
Low fuel level shutdown
Open set narrow tankbase
Skidbase for CALG enclosure sets
DEFRA bunded fuel tank
Low fuel level alarm
Compact skidbase for open sets
High fuel level alarm
Optional
PGS Test report @ 0.8 power factor
PGS Test report @ 1.0 power factor
Optional
Certification for CIS
Optional
Circuit breaker, IEC, 4 pole
Optional
Packing case - compact set
Packing case - canopied set
Complete this form to get a quote on the equipment you are interested in.
